There are a variety of methods for installing hardwood Flooring Waldorf Md . The nail down technique of laying hardwood floors has become very popular. For those learning how to install hardwood floor, there’s no simpler or straightforward technique than the nail down technique.
Unlike other methods which basically require you to be an amateur carpenter or even a professional carpenter, the nail down method on how to install hardwood flooring can be accomplished by anyone who can swing a hammer. Well, that’s not all it takes. You also have to be persistent, patient, and willing to try new things if you want to learn how to install hardwood floor. Also, you need to be willing to read the safety instructions that come with the tools you’ll be using.
Tools You’ll Need as Your Learn How to Install Hardwood Floor Panels
Broom and Dust Pan – You need to clean up constantly as you learn how to install hardwood floor to make sure no dirt, sawdust, or other debris get caught in between the grooves or under the boards.
Carpenter’s Crayon – Use this to create guidelines on your sub floor. You’ll also need it to draw lines where you’ll cut your hardwood panels.
Claw Hammer – Any areas near obstacles or walls where you can’t get enough space to swing a rubber mallet will have to be reached with your claw hammer.
Cutter Knife – Use this often for unforeseen activities involved as you learn how to install hardwood floor. But the main purpose of this device will be to cut out any excess wood when adjustments of only a millimeter or two need to be made.
Electric Drill and 3/32″ Drill Bit – Use this to drill your pilot holes, which should be slightly smaller in length and circumference than your nails. This will prevent your flooring panels from cracking when you put the nails in them.
Hardwood Flooring Nails (2″) – These nails are important because they will be what hold your floor in place.
Nailer – This can either be a hammer or pneumatic nail gun. The pneumatic nail gun is obviously faster and easier, but you have to get it calibrated just right so that the nails don’t go too far down into the wood and destroy your hardwood panels.
Rubber Mallet – This is your chance to pound your frustrations out as you learn how to install hardwood floor. Actually, you should pound them out gently to bring the surfaces of the two panels together perfectly. You don’t want to get them too far apart or your floor will have crevices. But if you pound them too hard together, you can damage them or push them so far together as to bow them.
Circular Saw – At the end of each row of boards as you go into the corner, you will need to cut your floor panels to fit. Any fixtures in the room will also have to be cut around.